. Italian . French
Mail form
> Azienda
> News
>Homepage >Products >Solutions to load the wheelchair inside the car >Wheelchair loading arm
>WHEELCHAIR LOADING ARM
>OTHER PHOTOS
 



 

This product facilitates the wheelchair loading in the rear side of the car.
It can be set up in all five doors cars and it must be combined with a sliding door or with a door operator.

 

Start the loading/unloading process by opening the door using the push-button handset (or switch).
The wheelchair loading arm can only start to operate after the door has reached its maximum opening.
Press the hand control button to drive out the loading arm.
When the loading arm has reached its maximum position outside the vehicle the wheelchair can be fastened onto the hooks of the arm. Press the control button to lift up the wheelchair and to place it inside the vehicle.

 
 

The automatic wheelchair loading arm is fitted with some safety features: the operation of the device automatically stops at the end of the cycle, or in case of an obstruction preventing any further operation. It works only when the front door is open.
Should a fault occur, you can use the wheelchair loading arm manually

 


The installation leaves no trace in the vehicle when disassembled: it can be easily taken away and allows, in this way, to use again the rear seats. This product is CE marked